This assembly is called the mode shifter assembly. My coil was open & saw YouTube video on how to repair. The exposed portions of spool are protected by fiberglass tape. The coil is wrapped around a white plastic spool with a small fuse in series. Down unenergized position for spin cycle. THE DESIGN Has a winding of wire & a gear in shape of a short hollow cylinder with gear teeth on top, when solenoid coil is powered, the gear is forced up during agitation cycle only. They keep talking about a surface mounted LED on top of the inverter board made on square PCB mounted on top of motor under a metal top. You must have access to info in service manual to get the washer in “Service mode.”. If 4 cycles are completed without the unit sending the lid switch being opened, it disables the motor. Been reading a lot about GE HYDROWAVE washers.ĭon’t bypass the lid switch. It has a 28-pin surface mount IC that has a small crater in it. Hopefully can reuse some of the components such as it’s 2 large electrolytic capacitors, 6-heavily heat sinked power transistors. Need a inverter board for GE 3-phase washing machine motor.
0 kommentar(er)
